LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 210 (Starter) >> On-Vehicle Testing >> Starter Relay Test

Starter Relay Test

WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove starter relay from Power Distribution Center (PDC). Using an ohmmeter, check for continuity between terminals No. 30 and 87A. If no continuity exists, replace relay. See Fig 1 .
  2. Check resistance between terminals No. 85 and 86. If resistance is not 70-80 ohms, replace starter relay.
  3. Connect battery leads to terminals No. 85 and 86. Check for continuity between terminals No. 30 and 87. If no continuity exists, replace starter relay.
Fig 1: Identifying Starter Relay Terminals
G93C76101Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals