LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Diagnosis - 42RH, 46RH & 47RH) >> Diagnostic Tests >> Verification Test VER-1A

Verification Test VER-1A

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure all engine components are connected. Reassemble and reconnect components as necessary. If another DTC was previously displayed but not repaired, return to TEST TC-1A and follow path specified by other DTC. If PCM has been changed, connect scan tool to data link connector. Erase fault messages. Using scan tool, reset all values with adaptive memory. Disconnect scan tool.
  2. Ensure no other fault messages remain. Turn A/C and blower on (if equipped). Drive vehicle for at least 5 minutes and attain a speed of at least 40 MPH. Ensure transmission shifts through all gears. Complete road test. Turn ignition off. Start engine and allow it to idle for at least 2 minutes. Turn ignition off. Reconnect scan tool and check for fault messages.
  3. If repaired DTC has reset, repair is not complete. Check if any Technical Service Bulletins (TSBs) apply and return to TEST TC-1A as necessary. If another DTC has set, return to TEST TC-1A and follow path specified buy other DTC. If no fault messages have set, repair is complete.
scientia non olet · About LEMON Manuals