LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Servicing - A/T) >> Adjustments >> Park/Neutral Position (PNP) Switch >> 30RH, 32RH, 42RE & 44RE

30RH, 32RH, 42RE & 44RE

WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. With transmission linkage properly adjusted, switch should allow starter operation in Park or Neutral only.
  2. To test switch, remove wire harness and test for continuity between center pin of switch and transmission case. Continuity should only exist when transmission is in Park or Neutral.
  3. Shift transmission into Reverse. Check for continuity between 2 outer switch terminals. Continuity should exist with transmission in Reverse only. With transmission in Reverse, check continuity between each outer switch terminal and transmission case. No continuity should exist between other terminals and transmission case.
  4. To replace switch, disconnect wire connector and unscrew switch from case. Move selector lever to Park and Neutral positions and ensure switch operating fingers are centered in switch opening.
  5. Install switch and NEW seal in case. Tighten switch to 24 ft. lbs. (33 N.m). Check fluid level and adjust as needed.
scientia non olet · About LEMON Manuals