LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Servicing - A/T) >> Adjustments >> Low-Reverse (Rear) Band >> 42RE & 44RE Transmissions

42RE & 44RE Transmissions

WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle, drain transmission fluid and remove oil pan. Locate adjusting screw on rear servo lever. See Fig 1. Ensure lock nuts are backed off on rear band adjusting screws. Tighten rear band adjusting screws to 72 INCH lbs. (8.1 N.m).
  2. Loosen rear band adjusting screw 4 turns. Tighten band adjusting screw lock nut to specification while holding band adjusting screw. See TORQUE SPECIFICATIONS . Install oil pan and fill transmission with fluid.
Fig 1: Adjusting Low-Reverse Band
G96C04099Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals