Manual Bleeding
WARNING: This page is about a different car, the 1997 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Fill master cylinder. Install clear vinyl bleed hose onto right rear bleed valve. Place other end of hose in clean transparent container.
- Partially fill container with clean brake fluid. Submerge end of hose in fluid. Depress pedal and hold. Open bleed valve at least one turn.
- Close bleed valve. Release pedal. Repeat procedure until flow of brake fluid is clear and free of bubbles. Proceed to next bleed valve of brake bleeding sequence. See BLEEDING SEQUENCE table.
BLEEDING SEQUENCE
| Application | Sequence |
|---|---|
| All Models | RR, LR, RF, LF |