LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Disc & Drum) >> Removal & Installation >> Rear Wheel Bearings >> Installation

Rear Wheel Bearings: Installation

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Seat new races into drum or hub. Pack bearings using multi-purpose grease. Install inner bearing and new seal.
    NOTE: DO NOT reuse old grease seals.
  2. Clean and inspect spindle. Apply a thin coat of wheel bearing grease to polished surfaces. Install drum or hub on spindle. Install outer bearing, washer and adjusting nut.
  3. Tighten adjusting nut to 20-25 ft. lbs. (27-34 N.m). Back off adjusting nut 1/4 turn. Finger tighten adjusting nut. Position nut lock with slots in line with cotter pin hole on spindle. Install cotter pin, grease cap and wheel.
scientia non olet · About LEMON Manuals