LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Disc & Drum) >> Bleeding Brake System >> Bleeding Procedures >> Manual Bleeding

Manual Bleeding

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fill master cylinder. Install clear vinyl bleeder hose onto first bleeder valve to be serviced (RR). Place other end of hose in clean transparent container.
  2. Partially fill container with clean brake fluid. Submerge end of hose in fluid. Open bleeder valve 1-2 turns. Slowly depress brake pedal through its full travel.
  3. Close bleeder valve. Release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until brake fluid flows clear and free of bubbles. Proceed to next bleeder valve of brake bleeding sequence. See BLEEDING SEQUENCE .
NOTE: Check fluid level in master cylinder frequently when bleeding.
scientia non olet · About LEMON Manuals