Test 55F - Parking Lamps Will Not Turn Off
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see WIRING DIAGRAMS
. Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector.
- Disconnect headlamp switch connector from behind switch. If parking lamps go out, replace headlamp switch. If headlamps do not go out, turn ignition switch to OFF position. Go to next step.
- Disconnect Body Control Module (BCM) Gray connector. If parking lamps go out, replace BCM. If parking lamps do not go out, go to next step.
- Disconnect parking lamp relay. Parking lamp relay is located behind dash, below parking lamp switch. If parking lamps do not go out, repair short to battery voltage in Black/Yellow wire. If parking lamps go out, go to next step.
- Using DRB in ohmmeter mode, check resistance of parking lamp relay connector terminal "A" (Light Blue wire). If resistance is less than 5 ohms, repair short to ground in Light Blue wire. If resistance is more than 5 ohms, replace parking lamp relay.