LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 52D - Repairing Chime Inoperative W/ Seat BLT Unfastened

Test 52D - Repairing Chime Inoperative W/ Seat BLT Unfastened

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Ensure left front seat belt is unfastened and fully retracted. Using DRB, read seat belt switch status. If DRB does not display SEAT BELT CLOSED, go to TEST 12A. If DRB displays SEAT BELT CLOSED, go to next step.
  2. Fasten left front seat belt. If DRB does not display SEAT BELT OPEN, go to TEST 11A. If DRB displays SEAT BELT OPEN, replace body control module.
scientia non olet · About LEMON Manuals