LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 52C - Repairing Chime Inoperative With External Lamps On

Test 52C - Repairing Chime Inoperative With External Lamps On

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector.
  1. Turn headlamps on. Using DRB, read headlamp status. If DRB displays HEADLAMPS ON, go to step 4). If DRB does not display HEADLAMPS ON, go to next step.
  2. Turn headlamps off. Turn ignition switch to OFF position. Disconnect Body Control Module (BCM) Bone connector. BCM is located behind right kick panel. Turn headlamps on. Go to next step.
  3. Using DRB in voltmeter mode, check voltage on BCM Bone connector terminal No. 23 (Black/Yellow wire). If voltage is more than 10 volts, replace BCM. If voltage is less than 10 volts, repair open Black/Yellow wire.
  4. Ensure left front door is open. Using DRB, read left front door ajar switch status. If DRB displays LFDOOR AJAR CLOSED, go to TEST 43A  . If DRB does not display LFDOOR AJAR CLOSED, replace BCM.
scientia non olet · About LEMON Manuals