Left & Right Impact Sensors: Installation
WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
- Mount impact sensors with arrow pointing toward front of vehicle, on engine side of radiator closure panel. Install NEW screws and tighten to 90-120 INCH lbs. (10.1-13.6 N.m). Use only screws supplied with NEW sensor.
- Connect sensor electrical connector, ensuring locking tab is engaged. On left sensor, install coolant bottle, battery tray, engine computer and battery. Install cruise control servo (if removed). On both sensors, DO NOT connect negative battery cable at this time. Perform system operation check to ensure system is functioning properly. See SYSTEM OPERATION CHECK.