Air Bag Disabling
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
BEFORE servicing ANY steering column or air bag component, disconnect and shield negative (ground) battery cable. DO NOT
use any power driven tools while working near or with air bag.
- After disconnecting negative battery cable, wait 2 minutes to allow air bag system capacitor to deplete its residual charge.
- Remove 4 nuts attaching air bag module from back of steering wheel. Remove air bag module and cruise control switch (if equipped) and disconnect wire feeds. See Fig 1 . To enable air bag, reverse disable procedure.