Ignition Switch: Installation
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Install connectors in switch body. Ensure connector locks are engaged. Ensure switch is in LOCK position. Apply small amount of grease to park/lock pin and flag. Mount ignition switch on steering column. Ensure park/lock pin at back of switch engages park/lock slider linkage. Tighten mounting screws to 17 INCH lbs. (2 N.m).
- Install steering column covers. Install tilt lever (if equipped). Connect negative battery cable. Ensure lock cylinder and ignition switch are in LOCK position. Insert lock cylinder in switch until it bottoms. Insert key and rotate clockwise to end of travel. Check for proper switch operation.