Removal & Installation (Disc)
WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove wheel. Remove caliper. See REAR BRAKE CALIPER & PADS. Remove cap and hub nut.
- Remove hub and bearing assembly. To install, reverse removal procedure. Apply bearing grease to axle shaft before installing hub. Tighten hub nut to 124 ft. lbs. (168 N.m).