LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 193 (Disc & Drum) >> Removal & Installation >> Front Park Brake Cable >> Removal (5 Passenger Models)

Removal (5 Passenger Models)

WARNING: This page is about a different car, the 1994 Eagle Vision, 1994 Dodge Intrepid, 1994 Chrysler New Yorker, 1994 Chrysler LHS, and 1994 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove adjuster attaching bolts and nuts from floor pan. Move seat position adjuster for access. Disconnect wiring harness at carpet. Remove seat assembly.
  2. Remove shift knob from floor shifter. Shift knob is removed be removing 3/32 INCH Allen head set screw located on drivers side of shift knob and pulling strait up on shift knob.
  3. Remove upper center console cover from vehicle if equipped.
  4. Remove drivers side door opening sill molding. Remove drivers side cowl kick molding to expose park brake pedal mechanism.
  5. Remove rear console mounting bracket from park brake cable reaction bracket. Remove rear passenger compartment heat duct from vehicle, for access to park brake cables.
    6. NOTE: The throttle pedal and bracket have to be removed from the dash panel to allow carpet to be folded back.
  6. Fold back carpeting to expose front park brake cable and routing clips.
scientia non olet · About LEMON Manuals