LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Overhaul - 46 & 47 Automatic Transmission Series) >> Transmission Component Disassembly & Reassembly >> Rear Clutch >> Disassembly

Rear Clutch: Disassembly

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1996 Dodge Ram Wagon, 1996 Dodge Ram Van, 1996 Dodge Pickup, 1996 Dodge Dakota, and 1996 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove selective snap ring. See Figure . Remove reaction plate, clutch discs and clutch plates. Note direction of component location for reassembly reference.
  2. Remove pressure plate, waved snap ring and spacer ring. Note direction of piston spring installation. Remove piston spring.
  3. Remove clutch piston and piston retainer from rear clutch retainer. Using twisting motion, remove clutch piston from piston retainer.
  4. Remove fiber thrust washer from input shaft. Remove and discard piston seals. DO NOT  remove seal rings from input shaft unless seal rings are damaged. If removing input shaft, remove snap ring. Using press, press input shaft from rear clutch retainer.
scientia non olet · About LEMON Manuals