LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Overhaul - 46 & 47 Automatic Transmission Series) >> Transmission Component Disassembly & Reassembly >> Overrunning Clutch >> Disassembly

Overrunning Clutch: Disassembly

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1996 Dodge Ram Wagon, 1996 Dodge Ram Van, 1996 Dodge Pickup, 1996 Dodge Dakota, and 1996 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing overrunning clutch cam, remove set screw from overrunning clutch cam. See Fig 1 . Insert punch through overdrive piston retainer bolt holes in rear of transmission case.
  2. Using hammer, tap overrunning clutch cam from transmission case. It may be necessary to alternate from hole to hole to prevent overrunning clutch cam from binding in transmission case.
Fig 1: Removing & Installing Set Screw For Overrunning Clutch Cam
G92G13371Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals