Cleaning & Inspection
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1996 Dodge Ram Wagon, 1996 Dodge Ram Van, 1996 Dodge Pickup, 1996 Dodge Dakota, and 1996 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Clean and inspect components for damage. Inspect all machined surfaces for pitting or damage.
- Ensure pump vent is not cracked and is secure in oil pump housing. See Figure . Replace oil pump housing if pump vent is loose or cracked.
- Install both pump gears in oil pump housing. Using feeler gauge, measure outer pump gear-to-oil pump housing clearance.
- Place straight edge on oil pump housing, above both pump gears. Using feeler gauge, measure pump gear end clearance between each pump gear and straight edge.
- Align one tooth on outer pump gear with one tooth on inner pump gear. Measure pump gear tooth clearance between the teeth on the pump gears. Replace components if clearance is not within specification. See OIL PUMP SPECIFICATIONS TABLE .
OIL PUMP SPECIFICATIONS
| Application | In. (mm) |
|---|---|
| Outer Pump Gear-To-Housing Clearance | .0035-.0075 (.089-.190) |
| Pump Gear End Clearance | .0035-.0075 (.089-.190) |
| Pump Gear Tooth Clearance | .0035-.0075 (.089-.190) |