Torque Converter Stall Speed Test Procedure
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1996 Dodge Ram Wagon, 1996 Dodge Ram Van, 1996 Dodge Pickup, 1996 Dodge Dakota, and 1996 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Install tachometer. Ensure transmission fluid level is correct. Start and operate engine until transmission fluid is at normal operating temperature.CAUTION: DO NOT open throttle to wide open position for more than 5 seconds or transmission may be damaged. If performing more than one torque converter stall speed test, operate engine at 1000 RPM with transmission in Neutral for at least 1 minute to cool transmission fluid before performing next torque converter stall speed test.
- Block front wheels. Apply parking and service brakes. Place transmission in Drive. Open throttle to wide open position for no more than 5 seconds and note engine RPM and then release throttle. This is the torque converter stall speed. For stall speed specification, see TORQUE CONVERTER STALL SPEED SPECIFICATIONS TABLE .
- Once torque converter stall speed is obtained, place transmission in Neutral. Operate engine for 1 minute, allowing transmission to cool. Stop engine. Place transmission in Park. Remove tachometer.
TORQUE CONVERTER STALL SPEED SPECIFICATIONS
| Application | RPM | |
|---|---|---|
| 1995 Models | ||
| Dakota & Ram Van | 1750-2150 | |
| Grand Cherokee | 1750-2300 | |
| Pickup | 1800-2300 | |
| 1996 Models (All) | 1800-2300 | |
NOTE:
Use following symptoms to trouble shoot results of torque converter stall speed test.