LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Overhaul - 46 & 47 Automatic Transmission Series) >> On-Vehicle Service >> Oil Cooler Line Disconnect Fittings >> Installation

Oil Cooler Line Disconnect Fittings: Installation

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 1996 Dodge Ram Wagon, 1996 Dodge Ram Van, 1996 Dodge Pickup, 1996 Dodge Dakota, and 1996 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. If installing NEW disconnect fitting, apply Loctite 242 on disconnect fitting before installing. Ensure end of oil cooler line is clean. Insert oil cooler line into disconnect fitting.
    CAUTION: After installing oil cooler line, pull outward on oil cooler line to ensure oil cooler line is locked in the disconnect fitting and retaining clip is fully seated.
  2. Push oil cooler line inward until a snap or click is heard when retaining clip seats in oil cooler line. Pull outward on oil cooler line to ensure oil cooler line is locked in the disconnect fitting.
Fig 1: Identifying Oil Cooler Line Disconnect Fittings
G94C38523Courtesy of CHRYSLER CORP.
Fig 2: Removing Oil Cooler Line From Disconnect Fitting (Type 2 Shown; Others Are Similar)
G94D38524Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals