LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls - Tests W/Codes - Body Control Computer (Convert)) >> Vehicle Communications Tests >> Test 7G - Short To Battery

Test 7G - Short To Battery

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR  IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
  1. Using an external ohmmeter, check resistance between Body Control Module (BCM) Gray connector terminal No. 6 (Tan wire) and BCM Bone connector terminal No. 8 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Tan wire and Violet/Brown wire.
  2. If resistance is more than 5 ohms, check resistance between BCM Gray connector terminal No. 6 (Tan wire) and BCM Bone connector terminal No. 7 (White/Black wire). If resistance is less than 5 ohms, repair short between Tan wire and White/Black wire.
  3. If resistance is more than 5 ohms, check resistance between BCM Gray connector terminal No. 3 (Tan/Red wire) and BCM Bone connector terminal No. 8 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Tan/Red wire and Violet/Brown wire.
  4. If resistance is more than 5 ohms, check resistance between BCM Gray connector terminal No. 3 (Tan/Red wire) and BCM Bone connector terminal No. 7 (White/Black wire). If resistance is less than 5 ohms, repair short between Tan/Red wire and White/Black wire.
  5. If resistance is more than 5 ohms, check resistance between BCM Bone connector terminals No. 5 (Yellow/Red wire) and No. 8 (Violet/Brown wire). If resistance is less than 5 ohms, repair short between Yellow/Red wire and Violet/Brown wire.
  6. If resistance is more than 5 ohms, check resistance between BCM bone connector terminals No. 5 (Yellow/Red wire) and No. 7 (White/Black wire). If resistance is less than 5 ohms, repair short between Yellow/Red wire and White/Black wire.
  7. If resistance is more than 5 ohms, using DRB in ohmmeter mode, check resistance of BCM Bone connector terminal No. 14 (Black/Light Green wire). If resistance is more than 5 ohms, repair open Black/Light Green wire.
  8. If resistance is less than 5 ohms, check resistance of BCM bone connector terminal No. 15 (Gray/Tan wire). If resistance is more than 5 ohms, repair open Gray/Tan wire. If resistance is less than 5 ohms, replace BCM.
scientia non olet · About LEMON Manuals