LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls - Tests W/Codes - Body Control Computer (Convert)) >> Self-Diagnostic Tests >> Test 54A - Repairing Traveler Illumination Problem

Test 54A - Repairing Traveler Illumination Problem

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR  IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Turn park lamps on. If traveler module does not dim with dimmer control, disconnect traveler module connector. Traveler module is located in center section of dash. Go to next step.
  2. Put DRB in voltmeter mode. Measure voltage at traveler connector terminal No. 5 (Orange wire). If voltage is less than 4 volts, go to TEST 40A. If voltage is more than 4 volts, replace traveler module.
scientia non olet · About LEMON Manuals