LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls - Tests W/Codes - Body Control Computer (Convert)) >> Self-Diagnostic Tests >> Test 53B - Diagnosing Traveler Buttons

Test 53B - Diagnosing Traveler Buttons

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR  IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Using DRB, read traveler switch status. If DRB displays CLOSED for traveler step or US/M buttons, replace traveler module. If DRB does not display CLOSED, go to next step.
  2. Press traveler step button and observe DRB. If DRB does not display CLOSED, replace traveler module. If DRB displays CLOSED, press US/M button and observe DRB. If DRB does not display CLOSED, replace traveler module. If DRB displays CLOSED, system is okay at this time.
scientia non olet · About LEMON Manuals