Test 28A - Right Brake Lamp Out

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.

Disconnect lamp outage module 14-pin connector. Check, clean and repair connections as needed. Put DRB in voltmeter mode. Measure voltage at lamp outage module 14-pin connector terminal No. 8 (White/Tan wire). Press brake pedal. If voltage is more than 10 volts, replace lamp outage module. If voltage is less than 10 volts, repair open White/Tan wire between lamp outage module connector and right brake lamp switch connector.