Test 26B - Headlamp Power Feed

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagram, see WIRING DIAGRAMS . Perform TEST VER-1 after each repair.

Put DRB in voltmeter mode. Measure voltage at power distribution center terminal No. 49 (bottom terminal of second fuse from left on bottom row, Black wire). See Figure . If voltage is more than 10 volts, repair open Red/White wire between power distribution center and low beam headlamp relay. See Figure . If voltage is less than 10 volts, repair power distribution center.