LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Engine Controls - Tests W/Codes - Body Control Computer (Convert)) >> Self-Diagnostic Tests >> Test 18B - Park Brake Engaged

Test 18B - Park Brake Engaged

WARNING: This page is about a different car, the 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagram, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
  1. Disconnect parking brake switch connector. Connect jumper wire between parking brake switch connector Black/White wire and ground. If DRB does not display PRK BRAKE : OPEN, replace parking brake switch. If DRB displays PRK BRAKE : OPEN, go to next step.
  2. Disconnect jumper wire. Gain access to Body Control Module (BCM), located behind right kick panel. With connectors connected, connect jumper wire between BCM Natural connector terminal No. 9 (Black/White wire) and ground. If DRB displays PRK BRAKE : OPEN, replace BCM. If DRB does not display PRK BRAKE : OPEN, repair open Black/White wire between BCM Natural connector and parking brake switch connector.
scientia non olet · About LEMON Manuals