Blade & Sealed Pin Terminals
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Remove terminal wedge lock. Insert appropriate tool at location "A". See Fig 1 . Gently pry plastic locking finger away from terminal. Pull gently on wire until terminal releases.
- To install terminal, push terminal into its cavity until clicking sound is heard. Pull wire lightly to ensure terminal is locked. Reinstall terminal wedge lock. On sealed pin terminals, always reinstall seal after repairs are made. Replace terminals if defective. See REPLACING TERMINALS .