Intermittent Codes
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
If fault code is intermittent and malfunction is not present, problem may not be located while performing diagnostic tests. In this case, stored code can only suggest an area to inspect. If SAFING SENSOR OPEN, SAFING SENSOR SHORT, LOW STORED ENERGY, or DIAGNOSTIC MODULE TYPE #1, #2 or #3 fault codes set intermittently, ASDM should be replaced. If any other intermittent codes set, check for loose or corroded connections, damaged components, or damaged wiring. If no obvious problems are found, erase stored codes. With ignition switch on, wiggle wiring harness and connectors. Recheck for codes periodically as you work through system. This procedure may uncover a difficult problem to locate.