LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (4.0L 6-CYL - VIN [S]) >> Removal & Installation >> Rocker Arms >> Installation

Rocker Arms: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, 1995 Jeep Cherokee, 1994 Jeep Wrangler, and 1994 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install all reused components into original locations. Ensure the bottom ends of the push rods are centered in the valve lifters. Lubricate the pivot contact area of rocker arms with Mopar Engine Oil Supplement (4318002). Install cap screws loosely, and then tighten alternately one turn at a time to specification. Refer to TORQUE SPECIFICATIONS .
  2. Reverse removal procedure to complete installation. Pour remaining engine oil supplement over entire valve train. Supplement must remain in engine oil for at least 1000 miles (1600 km). Refill cooling system. Adjust ignition timing. Check for leaks.
scientia non olet · About LEMON Manuals