Oil Pan: Removal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, 1995 Jeep Cherokee, 1994 Jeep Wrangler, and 1994 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Raise and support vehicle at side sills. Drain engine oil. Disconnect exhaust pipe at exhaust manifold. Disconnect exhaust hanger at catalytic converter. Lower exhaust pipe. Remove starter. Remove flywheel access cover.
- Position jackstand directly under vibration damper. Place wooden block between vibration damper and jackstand. Remove through bolts from engine mounts. Raise engine enough to remove oil pan. Remove oil pan retaining bolts. Remove oil pan by sliding it to rear.