LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (4.0L 6-CYL - VIN [S]) >> Removal & Installation >> Front Cover Oil Seal >> Installation

Front Cover Oil Seal: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, 1995 Jeep Cherokee, 1994 Jeep Wrangler, and 1994 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position seal on Seal Installer (6139), with seal open end facing toward cover. Apply thin coat of RTV sealant on outside diameter of seal. Lightly coat crankshaft with engine oil.
  2. Position installer over end of crankshaft. Insert draw screw into end of crankshaft. Tighten draw screw nut until seal is fully seated in front cover. Remover installer. Check seal for proper installation. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals