LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (2.5L 4-CYL - VIN [P]) >> Removal & Installation >> Rocker Arms >> Installation

Rocker Arms: Installation

WARNING: This page is about a different car, the 1995 Jeep Wrangler and 1994 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate push rod ends with Mopar Engine Oil Supplement (4318002). Install push rods into their original locations. Ensure bottom end of each push rod is centered in valve lifter.
  2. Lubricate pivot contact area of each rocker arm with engine oil supplement. Install rocker arms, pivots and bridges into their original locations. Loosely install cap screws, then tighten alternately one turn at a time to specification. Reverse removal procedure to complete installation.
  3. Pour remaining engine oil supplement over entire valve train. Supplement must remain in engine oil for at least 1000 miles (1600 km), but need not be drained until next scheduled oil change.
scientia non olet · About LEMON Manuals