Exhaust Manifold: Installation

WARNING: This page is about a different car, the 1995 Jeep Wrangler and 1994 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.

Clean all gasket surfaces. Install intake and exhaust manifolds together, using NEW gasket. Ensure exhaust manifold is centrally located over end studs and spacer. Tighten bolt No. 1 to specification. See TORQUE SPECIFICATIONS . Tighten bolts No. 2 through 5 to specification in sequence. See Figure.
Install new spacers over cylinder head studs. Tighten nuts No. 6 and 7 to specification. To complete installation, reverse removal procedure. Start engine and check for leaks.