Removal & Installation: Camshaft: Removal
WARNING: This page is about a different car, the 1995 Jeep Wrangler and 1994 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Drain cooling system. Discharge A/C system (if equipped), using approved refrigerant recovery/recycling equipment. Remove A/C condenser (if equipped) and radiator. Mark distributor and engine block for installation reference. Remove distributor and ignition wiring. Remove rocker arms, bridges, pivots and push rods. See ROCKER ARMS .
- Remove valve lifters using Hydraulic Valve Lifter Remover/Installer (C-4129-A). Tag each valve lifter for installation reference. Remove timing chain and sprockets. See TIMING CHAIN & SPROCKETS . Remove camshaft.