LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (2.5L 4-CYL - VIN [P]) >> Engine Oiling >> Oil Pump >> Reassembly & Installation

Reassembly & Installation

WARNING: This page is about a different car, the 1995 Jeep Wrangler and 1994 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant to pick-up pipe and pump cover area prior to installation. To install pick-up tube, use Pipe Installer (7624). Ensure pick-up pipe support bracket is aligned with pump cover bolt. If relief valve is replaced, ensure replacement valve is same diameter as that removed.
  2. Fill pump cavity with petroleum jelly. Install cover. Tighten cover bolts to specification. Check pump gears for freedom of rotation. Install new gasket and oil pump. Tighten retaining bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals