LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 9A - No Chime With Turn Signals On

Test 9A - No Chime With Turn Signals On

WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. If a speedometer problem exists, go to TEST 36A . If a speedometer problem does not exist, turn ignition on, engine off. Check turn signal operation. If turn signals do not operate properly, see appropriate INSTRUMENT PANEL article in the ACCESSORIES/SAFETRY EQUIP section as listed below. If turn signals operate properly, go to next step.
  2. Turn left turn signal on. Using scan tool, read left turn signal status. If scan tool does not display OPEN then CLOSED, go to TEST 9B . If scan tool displays OPEN then CLOSED, go to next step.
  3. Turn right turn signal on. Using scan tool, read right turn signal status. If scan tool does not display OPEN then CLOSED, go to TEST 9C . If scan tool displays OPEN then CLOSED, system is okay at this time.
scientia non olet · About LEMON Manuals