LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Engine Controls - Tests W/Codes - Body Control Computer) >> Self-Diagnostic Tests >> Test 94A - Seat Belt Lamp On Constantly

Test 94A - Seat Belt Lamp On Constantly

WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  in this article. For appropriate wiring diagram, see WIRING DIAGRAMS  section at the end of this article. Perform TEST VER-1B  after each repair.
  1. Turn ignition off. Disconnect Body Control Module (BCM) Blue connector. BCM is located behind left side knee panel. Check and repair connections as necessary. If connections are okay, go to next step.
  2. Turn ignition on. If seat belt warning lamp is off, replace BCM. If seat belt warning lamp is on, repair short to ground in Dark Blue/Red wire.
scientia non olet · About LEMON Manuals