Test 32A - EIC Diagnostic Trouble Codes
WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Always turn ignition off prior to disconnecting or connecting any module connector.
Observe scan tool screen for Diagnostic Trouble Codes (DTCs). Read and note DTCs displayed. Perform corresponding procedure/test indicated in INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODES table.
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODES
| Problem | DTC | Test | ||||
|---|---|---|---|---|---|---|
| No Bus Activity | 01 | TEST 31A | ||||
| No Body Computer Message | 02 | TEST 106A | ||||
| No Engine Controller Message | 04 | TEST 107A | ||||
| Bus Loop Message Failure | 08 | (1) | ||||
| Display Driver Ckt. Failure | 10 | (1) | ||||
| Microcomputer Intrnl. Failure | 20 | (1) | ||||
| Power Supply Short Ckt. | 40 | (1) | ||||
| Body Comp. Odometer Failure | 80 | (2) | ||||
|
||||||