LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Controls - Tests W/Codes - 5.2L) >> Self-Diagnostic Tests >> Test TC-23E - IAC Driver #4 Control Circuit

Test TC-23E - IAC Driver #4 Control Circuit

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION  in this article. For wiring diagram, see WIRING DIAGRAMS  section at the end of this article.
  1. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Inspect connector for damaged, pushed-out or miswired terminals. Repair as necessary. Perform TEST VER-2  . If connector is okay, go to next step.
  2. Using an external ohmmeter, check resistance of Idle Air Control (IAC) motor driver No. 4 circuit (Gray/Red wire) between IAC motor connector and PCM terminal No. 59. If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2  . If resistance is more than 5 ohms, repair open Violet/Black wire or Gray/Red wire. Perform TEST VER-2  .
scientia non olet · About LEMON Manuals