LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Controls - Tests W/Codes - 5.2L) >> Self-Diagnostic Tests >> Test NTC-4A - Checking Coolant Sensor Calibration

Test NTC-4A - Checking Coolant Sensor Calibration

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Using scan tool, read Engine Coolant Temperature (ECT) sensor value. If ECT sensor temperature is more than 180°F (82°C), allow engine coolant to cool to 150°F (66°C). Start engine. Allow engine to reach normal operating temperature of more than 180°F (82°C). If ECT sensor value does not increase smoothly, repair cooling system as necessary and replace ECT sensor. Perform TEST VER-2  . If ECT sensor value increases smoothly, go to next step.
  2. If ECT sensor value did not reach 180°F (82°C) or more, repair cooling system as necessary and replace ECT sensor. Perform TEST VER-2  . If ECT sensor value reached 180°F (82°C) or more, system is functioning properly. Test is complete.
scientia non olet · About LEMON Manuals