Test NTC-10A - Checking Solenoid Operation
WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit and connector terminal identification, see CONNECTOR IDENTIFICATION
in this article. For wiring diagram, see WIRING DIAGRAMS
section at the end of this article.
- Using scan tool, actuate purge solenoid. While touching top of purge solenoid, feel for operation. If purge solenoid does not operate, replace purge solenoid. Perform TEST VER-2 .
- If purge solenoid operates, actuate EGR solenoid. While touching top of EGR solenoid, feel for operation. If EGR solenoid does not operate, replace EGR solenoid. Perform TEST VER-2 . If EGR solenoid operates, test is complete.