Inactive DTC Condition

WARNING: This page is about a different car, the 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

This procedure applies if you have been sent here from diagnostic tests and have just attempted to simulate the condition that initially set the fault message. The following additional checks may assist in identifying a possible intermittent problem:

Visually inspect related wiring harness connectors for broken, bent, pushed out or corroded terminals.
Visually inspect related wiring harnesses for chafed, pierced or partially broken wires.
Check if any Tech Service Bulletins (TSBs) apply to vehicle.