Test 3A - Diagnosing Fuel Level Sense Circuit To Traveler
WARNING: This page is about a different car, the 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION table. For wiring diagram, see WIRING DIAGRAMS. After each repair, perform TEST VER-1.
- Check if fuel gauge is functioning properly. If fuel gauge is not functioning properly, go to TEST 3B. If fuel gauge is functioning properly, go to next step.
- Turn ignition switch to OFF position. Disconnect fuel tank sending unit connector. See Fig 1 . Disconnect traveler module 7-pin connector. See Figure . Turn ignition switch to ON position. Go to next step.
- Using DRB in voltmeter mode, check voltage on traveler module 7-pin connector terminal No. 6 (Dark Blue wire). If voltage is more than 7.5 volts, replace traveler module. If voltage is less than 7.5 volts, repair open Dark Blue wire.