Test 2C - Diagnosing Panel Light Dimmer Circuit To Traveler
WARNING: This page is about a different car, the 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION table. For wiring diagram, see WIRING DIAGRAMS. After each repair, perform TEST VER-1.
- Ensure parking lights are on and headlight dimmer switch is in center position. Using DRB in voltmeter mode, check voltage on fuse No. 5 (Tan wire) in fuse block. See Figure . If voltage is more than 10 volts, go to step 3). If voltage is less than 10 volts, go to next step.
- Access headlight switch 9-pin connector. DO NOT disconnect headlight switch 9-pin connector. Backprobe headlight switch 9-pin connector terminal "I" (Tan wire). If voltage is more than 10 volts, repair open Tan wire. If voltage is less than 10 volts, replace headlight switch.
- Install fuse No. 5 into fuse block. Turn ignition switch to OFF position. Disconnect traveler module 7-pin connector. See Figure . Using DRB in voltmeter mode, check voltage on traveler module 7-pin connector terminal No. 3 (Orange wire). If voltage is not 3-9 volts, repair open Orange wire. If voltage is 3-9 volts, replace traveler module.