LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Traveler Module) >> Diagnostic Charts >> Test 1C - Traveler Elapsed Time (ET) Problem

Test 1C - Traveler Elapsed Time (ET) Problem

WARNING: This page is about a different car, the 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS. After each repair, perform TEST VER-1.
  1. Turn ignition switch to OFF position. Disconnect traveler module 7-pin connector and visual message center connector. See Figure . Check connectors for damage. Repair and clean connectors as necessary. If connectors are okay, go to next step.
  2. Turn ignition switch to ON position (engine off). Using DRB in voltmeter mode, check voltage on traveler module 7-pin connector terminal No. 7 (Pink wire). If voltage is less than 10 volts, repair open Pink wire. If voltage is more than 10 volts, replace traveler module.
scientia non olet · About LEMON Manuals