LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Rocker Arms >> Installation

Rocker Arms: Installation

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate "V8" mark stamped on vibration damper (located 17.5° ATDC from cylinder No. 1 firing mark). Rotate engine, by hand, until "V6" mark lines up with TDC mark on timing chain cover.
  2. Install rocker arm and pivot assemblies and tighten bolt to 21 ft. lbs. (28 N.m). Wait 5 MINUTES before starting engine to allow valve lifters to bleed down after rocker arm installation. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals