LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Oil Pan >> Removal (Dakota 2WD)

Removal (Dakota 2WD)

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Remove oil dipstick and distributor cap. Raise and support vehicle. Drain engine oil.
  2. Remove exhaust pipe. Loosen side engine mount bolts. Slightly raise engine. When engine is at adequate height, install bolts in side engine mount-to-frame bracket holes to support engine.
  3. Lower engine, and allow it to rest on bolts installed in side engine mounts. Remove bolts, oil pan and gaskets.
scientia non olet · About LEMON Manuals