LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Front Cover Oil Seal >> Installation

Front Cover Oil Seal: Installation

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use Seal Installer (6635) for seal installation. Installer should fit with minimum interference. If installer does not fit, front cover must be removed and installed properly.
  2. Position small diameter of oil seal over seal installer. Using vibration damper bolt, tighten seal installer to draw seal into position. Remove vibration damper bolt and seal installer. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals