LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Distributor Drive Shaft Bushing >> Removal

Distributor Drive Shaft Bushing: Removal

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate crankshaft so No. 1 cylinder is at TDC on compression stroke. Remove distributor and distributor drive shaft. Insert Bushing Puller (C-3052) into bushing and thread down until tight.
  2. Hold bushing puller bolt, and rotate bushing puller nut until distributor drive shaft bushing is removed.
scientia non olet · About LEMON Manuals