LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 1996 >> Grand Cherokee Limited, 5.2 Y >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (5.2L V8 Gas - VIN [Y]) >> Removal & Installation >> Distributor Drive Shaft Bushing >> Installation

Distributor Drive Shaft Bushing: Installation

WARNING: This page is about a different car, the 1995 Jeep Grand Cherokee, 1995 Dodge Ram Wagon, 1995 Dodge Ram Van, 1995 Dodge Pickup, and 1995 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install NEW distributor drive shaft bushing over burnishing end of Bushing Installer (C-3053). Insert bushing installer and distributor drive shaft bushing into cylinder block.
  2. Using hammer, drive bushing installer and distributor drive shaft bushing into cylinder block. Tighten nut to pull bushing installer through distributor drive shaft bushing. Tightening nut expands bushing tight in cylinder block and burnishes it to correct size.
    CAUTION: DO NOT ream distributor drive shaft bushing.
  3. Ensure No. 1 cylinder is at TDC on compression stroke. Install distributor drive shaft so slot is aligned from front to rear of engine. Install distributor with rotor positioned to No. 1 cylinder in distributor cap.
scientia non olet · About LEMON Manuals